Topics created by Hesus29

@hesus29 said in Duet 2 wifi Z-probe and Z ednstop min at the same time:

@fcwilt So yea i upgraded to 3.3 firmware today. I will remove m574 z1 s2 command. But can i use while homing z-probe and for safety endstop at the same time? should i make some g-code changes in home command?

Hi,

I always equip my printers with Z endstops and Z probes.

I always home with the Z endstop. It is quicker and simpler than using the Z probe. And since you can home Z first you don't need to have any Z moves in the X and Y homing if you don't want to.

I use the Z probe for:

setting the Z=0 datum leveling the bed creating the mech compensation height map

But that only happens if I work e.g. with M564 S0 H0, or if I have manually heated up the hotend beforehand.
Then it can happen that a G32 pin does not move out. The second time G32, the BLTouch works again and that until I do something manually again

@Hesus29 said in CoreXY layer shift but only in one direction:

Idk what caused this thing

Friction is the enemy of mechanical freedom.