Thank you all so much. Works everything fine now.... I will read some more wiki and learn all this machine code 
but thank you all for the support
Greetings and have good prints!
Joe
Best posts made by humbleJoe
-
RE: Homeing does not work - fadeing x Endstopposted in Firmware installation
-
RE: print quality issuesposted in Tuning and tweaking
@Phaedrux
Thank you very much for this post. By going through that page I found multiple problems. Now my machine prints perfect
Thank you alot
-
RE: Bed Heater missing as a toolposted in Firmware installation
Update:
Firmware Update was successful. I had to adjust some commands (RRF Config tool helped me a lot there).
And after correcting the connection error at the bed thermistor everything works now as intended and the charts are now looking fine as well. Thanks for the support @fcwilt !Have a nice day
Sincerely
Joe