Topics created by humbleJoe

@t3p3tony

I did as you said and it "kind of worked".

So i am now able to get connected to the board. However when ever I make a change in the config.g file (eather by putting SD in PC or by web edit) the system will not be able to get connected again. (f.ex. I changed the IP adress and after that I was not able to connect to the printer (on eather IP adress.

So far I havent tested that much but I will try to soon to maybe get an idea.

@humblejoe I guess you have to do a PID calibration https://duet3d.dozuki.com/Wiki/Tuning_the_heater_temperature_control

I had the same before I knew I had to do one 🙂

@elmoret
Thanks a lot. I'll see if i can get this fixed 🙂

@Phaedrux
Thank you very much for this post. By going through that page I found multiple problems. Now my machine prints perfect ❤

Thank you alot 🙂

Thank you all so much. Works everything fine now.... I will read some more wiki and learn all this machine code 🙂 but thank you all for the support 🙂

Greetings and have good prints!
Joe