Posts made by ixlix

@AlexZ Id like to know about this too. There is also the Beacon sensor which looks good too.

@yonutz33

DId you reverse the connectors like in that guide for the Ender 3?

Ok thanks. There are these motors but they have an inductance of 12mh.

https://www.omc-stepperonline.com/nema-17-stepper-motor/nema-17-bipolar-09deg-36ncm-51ozin-09a-54v-42x42x40mm-4-wires-17hm15-0904s.html?mfp=149-step-angle[0.9]%2C71-single-shaft-dual-shaft[Single Shaft]

Or something like this: https://www.banggood.com/JKM-Nema-17-0_9-Degree-42mm-Two-Phase-Hybrid-Stepper-Motor-1_33A-34mm-For-CNC-p-990669.html?cur_warehouse=CN

What kind of torque do i need to run a Hypercube Evolution style corexy utilising linear rails?

Im still on 12v but have no issue upgrading it to 24v if i'll get a quieter, smoother machine.

Hi. I'm trying to decide on some new stepper to match my Maestro.

Im more concerned about getting a nice quiet solution as my current steppers (OMC 2004S1 models) seem to vibrate quite a lot. If i run them with anything more than about 600-700 milliamps they vibrate immensely mostly at low speeds, even with no belts attached. Im thinking i might try some 0.9 degree motors as some people have had success reducing vibration when they switched to them.

Is a lower inductance or a lower rated current better? Im trying to decide between the;

• Wantai 42BYGHM809 (1.68a 4.0mH inductance)
• Wantai 42BYGHM810. (2.4a 1.8mH)

Whats everyone's thoughts?

Alex