@Phaedrux Mark this one solved. The config you provided worked as a great baseline. That was nice of you to help out. Thanks again.

@Phaedrux Mark this one solved. The config you provided worked as a great baseline. That was nice of you to help out. Thanks again.

@Phaedrux Thank you so much! I'll be giving this a shot once my kiddos are asleep. I seriously can't thank you enough.

Absolutely, the problem is, I can't make heads or tails how to set up the dual Z and BLTouch. Using the config tool, when assigning steppers, it lists as

X
Y
Z
E0
E1
X
Y
Z
E0
E1

Doesn't seem to take the Duex5 in to account.

Bltouch should be pwm5, which shows up, but isn't powering up

I appreciate your help, unfortunately I'm not looking for a menu system for an Ender 3. Thank you though, for being helpful and prompt!

Hello, I've recently purchased:

Duet2Wifi
Deux5
PanelDue 7i

Firmware:

• 3.2.2 (2021-01-05)

• Server Version 1.23

• Web Control 3.2.2

The Printers Setup is currently:

• Cartesian

• Printable Area 235x235x240

• Dual Z Axis Using Z1 and E1

• BLTouch 3.1 (PWM7 on Duex5)

• Extruder is set to E2 (E2 on Duex5)

I use the Ender 3 settings in RRF Config tool for bed heat and steppers, they seem just fine.

Now, I promise I am not lazy, I'm just a stay at home father of three children all under 10 and all HIGH energy.
Now I've tried for three weeks to set this up, I'm having a difficult time of it. I'm not complaining, it's a great system and somewhat easy to use, I just can't seem to focus.

Would it be possible to get a working config/bed/retract/deploy.

I thank anyone reading this in advance. I appreciate the help.