Topics created by joe92

Thanks. i missed it 👍

I adjusted the config and the toolboard is now responding. Thanks to all😊

found the fault in the cable to the z switch. a broken wire has trigged the z stop 😅

@phaedrux have not understood the reference to numbering but have now correct, thanks

After entering the command the SD card can be selected but the connection is not permanent. if I print something on the es card and the connection is interrupted, the board restarts. but it doesn't matter, I use the upload & start function

it worked but first the temperature must be set to zero 👍🏻

Hello, I found the reason for the error message. after the update, the wifi connections are no longer sufficient. everything works well via direct lan (pc) connection. thank you for your help