@phaedrux

no markings at all

@phaedrux

I agree, but sorry to say my printer was installed with all the parts, and the seller did not no anything about it

alle probes that I can find is only with 3 wires.

do you think I have to buy a 3 wire probe or maybe bl touch ?

@phaedrux

There are no details on the probe and I was installed when I buy my Ender 3.

Do you think I have to buy bl touch?

But the probe do something, when there is no power to probe I just go down into the bed, and if it is connected to 5v or 24v it stops when z-probe gives 1000 in web control it stops and go up to 6.39 in z.

but it will not stop if I place something in front of the probe.

@phaedrux

At the extruder my probe have 4 wire

White
Black
Blue
Brown

Will that ever work with my duet ?

if i place it on 24v led is very clear ind the red light

@phaedrux said in Ender 3 duet wifi Mesh problem.:

C"^zprobe.in"

i does not work for me

now i have connected:
White= 5V.
Brown= Probe in
Grey= GND by the side of probein.

config: M558 P5 C"^zprobe.in" H5 F600 T3000 ; Z probe connected to Z endstop input

how can i check about my probe are 5v or 6-36v ?

If i see videos on youtube, the probe lights go non when it detecting someting, but mine has lights always and turn off when it see someting, but still don't stops

The LED bulb in probe is also very weak when lit.

@phaedrux

The probe is connected to Z stop, gnd to z stop gnd. 5v in PanelDue conn.

do you want to move z stop to z probe in ?

@phaedrux

If i do this: Send command G30 to do a single Z probe. This will deploy the probe (if applicable) and start the head descending or the bed rising.
Hold a suitable surface below the print head to trigger the Z probe. The probe should trigger and the Z movement should stop.

my probe lights switch to off, but i does not stop on the way down to zero.

@phaedrux

I already have done that. but I'm not sure about to check it

if I put in M401 I'm not really sure what that will do ?

I also have trouble with extruder calibration, when it is perfekt and I print a little thing, and after that check about 100mm then it is not 100 mm anymore, do you have any idea why it changes ?

@phaedrux

I will try to print 1 pcs more and then I will fine tune it.

Is there a way to test my z-probe?

I can see when my z is on 0, the light is going off on my probe sensor, but I does not stop if I place som metal in front of my sensor.

@phaedrux
so long so good

I was printing the 20 mm cube.

X= 20.16
Y= 20.12
Z= 19.89

how do i fine tune this to get closer to 20.00 mm ?

Is there any good finger rules for extruder speed ?