Posts made by larenzobrown

@droftarts heres a question why would the z axis be any different from any of the other axis?
that dosent make any sense at all

@larenzobrown config.g config.g

@larenzobrown my email address is larenzobrown@gmail.com or josica_b@yahoo.com

@droftarts ok ill send it to you

@larenzobrown can you send me a firmware package that you tested and I will load it to the board and see if it works on my board and we can go from there my email address is larenzobrown@gmail.com

I'm using the boss delta firmware 500 from seemecnc I didn't change anything on the firmware all I did was a pid tune and I'm using the se300 hotend assembly

@phaedrux I'm not trying to be defensive sorry I'm just frustrated I really like these controllers and I spent a lot of time and money building this unit to comecthis far and try do a test print to realize the board isn't working properly

Look I build cnc routers laser cutters and 3d printers for a living I've been doing so for over 15 years I know how to hook up stepper motors to a controller what I'm saying is this board is defective and has a bad Mosfet

@droftarts I get the message even when there are no motors plugged in

I bought a duet wifi from filastruder, all wires are identical as well as all motors using nema17, I connect to x motors work I connect to y motors work , I connect to z and motors don't work I get error messages saying something about short to ground reported by drivers phase might be disconnected which is incorrect because all my wiring are the same and the work on all the other axis