Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
Update: I'm still not 100% sure what could be causing this but I turned off my RaspberryPi on the other side of my house and I havn't gotten any connection errors today… That could be the interference source even if it feels very strange..
Not perfect but waaay better than before! I will try multiple prints and decrease flow with 5% at a time and see where I get the best result
https://goo.gl/photos/fsekpNx1NPaj3i5SA
1. No, it does not reconnect Although it always works if I heat the bed first.
2. I changed to relative extrusion and now it print. I have some calibration to do but it looks fine at this point.
Thank you al ot for your support!!
