Hi, I`m using two bed heaters for mi heated bed. Is it possible to make an average of the two thermistors to control both of them as one unique heated bed?

Hi, I need to control an external device with current modulation from 0 to 85 mA. Is there a way I can control it with a Duet3???

Thanks in advance

@pcr it does light up, it makes a couple of deploys and rectracts and then it stops working. The red led is light up but then it doesn´t do anything when I run m280 commands

everything is connected to io5 port. Brown and black are connected to GND, red to 5v, yellow to io5.out and white to io5.in

@t3p3tony everything is connected as that guide explains. I`m connecting everything to the io5 port. The deployprobe and retract are located at sys folder being m280 p0 s90 and m280 p0 s10.

Hi I'm trying to use a BLTouch on a DUET3 6HC but it can't make it work. This is my config
M558 P9 C"^io5.in" H5 F100 T2000
M950 S0 C"io5.out" ; Servo
G31 P25 X0 Y55 Z2