@dc42 Thank you so much sir! That is exactly what we needed to here. I wanted to be sure, spec wise, we were shipping our units within reasonable tolerances. Thanks to @Phaedrux who helped us out a few months ago with getting our bed leveling just right, this was a final question we had. As always, great product and keep up the good work! We are very impressed with the QC standards you have and are proud to be shipping our BFP-ICARUS units with your hardware.
Mike
I couldn’t see anything either - glad I’m not going crazy! Ha.
It is 350mm using 26awg ribbon cable we buy from 3M. We make the cables in house.
I tried another (third) screen and that one worked too, just not sure why the first one won’t work with the PT100.
Apologize for the late reply here - but here are some pictures if you see anything I missed.
Thank you!
@dc42 said in PT100 Reads 2000C With PanelDue7 Plugged In Via 10 Pin Cable:
PanelDue
Thanks for the reply @dc42 and @Phaedrux .
Looks like the problem is solved - must be a short on the PanelDue7i screen. I took another one from inventory and swapped them out - everything is working fine. Thank you both for your suggestions!
@dc42 - Is there anything we can do to fix the one screen we have? Or do we need to write it off?
Thanks!
Mike
@Phaedrux - we did follow that page for setup, but I did not see the two to four wire conversion for the daughter board. I’ll try that tomorrow and report back. Thanks for the tip!
Mike
@Phaedrux Appreciate the info. We are open to ideas. We need to be able to give our customers a way to print offline - so I’m open to trying any ideas you or @dc42 may have.
Thanks!
Mike
Thanks for the reply @Phaedrux .
It is a 2 wire PT100 using the Duet Daughter board.
Hello Everyone,
We are upgrading our BFP-ICARUS units to PT100 sensors on the Dyze Pro hotends, and we noticed, upon installing the PT100 with the appropriate adapter board, the temperature will read 2000C with the PanelDue7 plugged in with the 10 pin ribbon cable. When the cable is unplugged, the PT100 works great and has an accurate reading. We used the four pin cable in the mean time to be able to use the touchscreen with the unit, but is there something we can do to be able to use the PT100 sensor and the PanelDue7 screen with the 10 pin ribbon cable? Somehow using the 10 pin ribbon cable is causing interference with the PT100 sensor and we are not sure how to troubleshoot this further. Some of our customers do not have Wifi and rely on offline printing via the MicroSD card on the touchscreen.
Thanks!
Mike
@dc42 Thank you so much sir! That is exactly what we needed to here. I wanted to be sure, spec wise, we were shipping our units within reasonable tolerances. Thanks to @Phaedrux who helped us out a few months ago with getting our bed leveling just right, this was a final question we had. As always, great product and keep up the good work! We are very impressed with the QC standards you have and are proud to be shipping our BFP-ICARUS units with your hardware.
Mike
Just seeing if anyone has any suggestions on this - thanks!
Mike