Posts made by mmb

@luca-f13 said in Duet Maestro with 12864 display:

@oliof said in Duet Maestro with 12864 display:

You will find the Duet Maestro Wiring Diagram on the Duet3d wiki. If you compare the pinout, you see that they differ. So at least the cabling needs to be redone.

But then, there are different 12864 controllers, and Duet only supports those based on ST7920 currently. I don't know if the Anet display uses ST7920 or something else.

omggggggg i'm stupid sorry
yes the cros of the cables was obvious to do but I have not absolutely thought about the processor I already understood everything thanks.
sometimes you have solutions under your nose but you don't see them

Sorry to reply to an old topic. But has someone figured this out? When I compare the pinout I see different names on the pins. Someone knows which LCD-pin has to be connected to which Maestro pin?

@Phaedrux said in Changing from maestro to WiFi board:

It would be best to set it up with a new config on the latest 3.2 firmware using the online config tool. You can compare the config it generates to your own and add anything you think it missing.

Thanks. I 'll try that.

@Veti said in Changing from maestro to WiFi board:

which wifi version. the new mini 5 wifi? duet wifi is nearing its eol.

I already have a duet2 Wifi. Thanks for the suggestion.

Hello

My printer is currently running a maestro board. I want to use that board in another machine and swap it with a WiFi board. What is the easiest way to do this?
Can I just put the maestro sd card in the WiFi board and then set up WiFi?
Or should I set it up as a new board and afterwards copy over the config.g?
Or is there a better way?