Topics created by morf

Ok i upgraded firmware to 2.04RC4 but it didn't solve my problems directly 🙂 however with new firmware onboard when the "stall" occured in the Console window I got message saying that print was paused due to low voltage.
I replaced my power supply and restart the print.
So far it seems that this problem is gone and it was connected to faulty PS.

@morf said in Ringing/echo after migration to duet3d, rootcause lookup:

M350 X128 Y128 Z128 E32 I0 ; NO interpolation M92 X640 Y640 Z640 E812 ; Set steps per mm

Using XYZ microstepping of 128 may lead to processor overload (although probably only in faster travel moves), so I suggest you reduce it to either 16 with interpolation, 32 or possibly 64. Your extruder microstepping and steps/mm look good.