Topics created by pedromelim

my problem was the slicer (cura) i had "use adaptive layers" on under experimental setting

You can still get open barrel type fork terminals, and purely U shaped terminals to crimp on bare wire.

Other than that as the other say, you can have different dies in one tool, but you'll wish you had one tool for each and its generally not cheaper.

0_1553683524832_714ede0a-2a94-447f-846b-ea09eea6f924-image.png
0_1553683495477_4eda9436-816c-498a-b144-f833b6e4c340-image.png

@snoozer said in Choosing a suitable power supply:

I split the mount. Intend to be able to manually change between hotends and also service it easy.

I did a rework of this mount, in Fusion 360: E3D V6 Hinged Extruder Bracket & Clamp for my little Monoprice Select v2. It's pretty kludgy so I didn't post my rework, but I have all the wires on plugs and can change the v6 clone on it in about 30 seconds. (Went with genuine v6 Gold for my CR-10S)

Kinda cool to have a hinge.

@pedromelim - Good luck with your project, keep us posted!