Best posts made by printerdad

@oliof Thanks!

@everyone Almost all of my questions have now been answered. Let this post die! (see my new post)

Ok here are some questions I have. Sorry if this info is readily available somewhere.

Duet 2 Ethernet - firmware 2.03 to 2.05

1. I am using 2 Z motors on headers ZA and ZB. Do I double the value for amps of the motor when I input the rated z amperage?

2. I have my BLtouch as a z-probe wired like this:
   BLTouch-------to------Duet
   out (white) --- Zprobe header, input
   GND (black) --- Zprobe header, GND
   +5V (red) --- Expansion, +5v (pin1.)
   Control (yellow) --- Expansion, Heater3 (pin 8.)
   GND (brown) --- Expansion, GND (pin 2.)
   Is this a typical configuration, and if so, do I set the servo control to E3 Channel?

3. For my fans, I have 2 extruders, each with their own heatsink fan. I also have a parts-cooling fan. I set the extruder fans for no thermostatic control, so they would be on all the time, wired to the non-pwm fan headers. I set the parts-cooling fan to no thermostatic control so my slicer can control it, wired to pwm control. Will those configurations operate my fans as intended?

4. How do I add a 3rd always-on fan for the duet board cooling? Possibly wire the two extruder, always-on fans in parallel?

5. I am not sure how to configure my tool. I currently have a single Tool 0, set with extruders E0 and E1, heaters E0 and E1, and fans 1 and 2. Is this a typical configuration?

6. Is there a spot to input the x-offset for the space between my two extruder nozzles?

Thanks for your time and advice, Dad