@Phaedrux

thanks for the good will to help.
I ran "erase" after an update destroyed everything. before everything ran perfectly with old firmware. I was able to solve the problem last night. with bossa I was able to upload a new firmware. with that "yat" could connect and i brought the board back to life. now i just have to renew all the obsolete commands. I'm in good spirits that everything will be back to normal soon...
best regards, manfred

@jay_s_uk I would like to apologize because I accidentally set the motor current too high. Now everything is back to the right volume.
I now leave the steps at 16 with "I1"
That's how it should be right!?

Thanks for the friendly help

@jay_s_uk I have now switched to 16 steps. The motors/drivers are now very loud. no more whispers

@jay_s_uk Thanks. I'll change it and report back with the result

Hello
Since the update I have had strong vibrations on the hotend whenever I print circles and arcs.
I ask for help.
I'm also unsure how much acceleration and jerk I should set
Thanks

@Phaedrux

thanks for the good will to help.
I ran "erase" after an update destroyed everything. before everything ran perfectly with old firmware. I was able to solve the problem last night. with bossa I was able to upload a new firmware. with that "yat" could connect and i brought the board back to life. now i just have to renew all the obsolete commands. I'm in good spirits that everything will be back to normal soon...
best regards, manfred

Hello

Is there a new driver for Windows 11? For duet 2 wifi.
I can't get rid of the yellow triangle at COM3... (error code 10, comport can not start). YAT does not recognize the PORT.
This means that no connection can be established with the board.!

Hallo
Gibt es vielleicht einen neuen Treiber für Windows 11?
Ich bekomme das gelbe Dreieck bei COM3 nicht weg... (Fehler Code 10). YAT erkennt den PORT nicht.
Somit kann auch keine Verbindung mit dem Board hergestellt werden.
Danke, Manfred

No, that's not what I want.
It would be nice if the G4 would only apply to one command and would not stop the entire printer. or another possibility is to execute a command for a certain time or after a certain time. in my case the lighting of the lighting with M42 ...
but I take note that this is not possible at the moment.
Thank you

ahh, ok ..., thanks for the explanation and your patience.

i turn on the lighting of my 3d printer via the M42 command. At the beginning of printing the lighting is switched on. i would like the light to switch off automatically after some time. even after activating the light via macro to control the printing process, the light switches itself off again after "xx" seconds.

my knowledge in gcode are obviously even worse than my english ...

thanks ... to add the command Pnn would be worth a try. will test on the weekend.

Hi

I switch an led with the m42 command. Is it possible the LED turning off automatically after "xx" seconds again? Unfortunately, g4 stop the entire printing process ... I just want to delay "this one" command alone.

Sorry, „translater-english“...

Thx