I have Issues with meshbed not working correctly.
Device is a CoreXY 310mm in cube 2 leadscrews.
Issue appears like too much compensation or compensation values are inverted.
on blue areas nozzle is scratching and diving into plate on red areas nozzle is too high.
where can I find the responsible part of code and manipulate it?
@phaedrux oh no, the rails are parallel. wonder where you could see something like that? only the x carriage is able to tilt by a small amount which is due to decent rigidity between rail and carriage in that case.
The issue really appears like to much compensation or the compensation value is inverted.
what is the advantage of a new thread?
@phaedrux I execute each step manually:
here is what character the bed always appears
about tilting: the printhead is running on a rail. Tilting is what carriage on rail is usual
Hey guys, I have the same issue as Col_Clucks.
My printer is a coreXY with 2 Leadscrews.
The code that Stephen6309 posted I don't see any improvement, it just automates the leveling.
Is there anywhere a compensation multiplier whoose value is set too high?