Where to begin...
6 pin molex is a poor choice, I've had to replace 3 already, chasing down bad crimps.
I had to sand the mounting hole for the heatsink a little just to get it to sit flush with the pcb. I can only get it to seat if I tighten the nut. Wonder if this causes any strain on the sensor.
Had the effector working briefly, after finding that just hanging a print cooling fan was enough to activate the strain gauge. After adjusting the sensitivity a little higher the turn off the led, now it's saying it's triggered before probing a point, but the led is not on.
I've had the sensitivity adjusted a few times and, well.. this just seems like too much hassle to get something working that should work out of the box.
Very frustrated by this product.