With the Duet3, does one need to run a bed leveling device or can one use the stall detection on the Z axis? I am in the middle of a swap to the Duet3 board in my Tevo Tornado and am contemplating if wiring up my BLTouch, now that I see that the RepRap firmware has implemented stall detection and one other feature, that the name of escapes at the moment, that can aid in deviceless bed detection on the Z axis.

@droftarts Thanks Ian, when I had initially posted this, I hadn't actually received my Duet yet and was just overly excited to get started that I started trying to bone up before it got here. I have the board in my hands now and I am off to the races. Thanks for the link and I'll see ya in the forums!

Hey, that is a great link. I was unable to find that. Maybe it is just a matter of the standard support pages not having the links yet.

I went to the documentation pages and all the links there are pretty much Duet 2. In fact the "Getting Started" links were exactly what I was looking for and the "Getting Started" on the documentation page is the Duet 2 "Getting Started" .

Anyway, thanks for heads up on the link.

k.

I have ordered a new Duet3 mainboard that I will be using to upgrade my Tevo Tornado printer. In preparation, I have been looking through the documentation and find very little Duet 3 documents and guides. Can I assume that the Duet 2 guides and documentation is applicable to Duet 3 or is there somewhere else that I should be looking or am I just out of luck?

I also don't see anywhere that describes new processes like connecting one's Raspberry Pi to the Duet board. That process would exist under the Duet 2 documentation, as far as I know.

Any advise will be greatly appreciated...

k.