Problem solved. I had to reduce the microstepping to 16. Works just fine now.
Best posts made by simplesimson
-
RE: Print stops always at the same Z hightposted in My Duet controlled machine
-
RE: IR probe and Duet Maestroposted in IR Height Sensor
Good morning. The Probe works as it should. It Reports 460-530 in trigger range.
I must have made a misstake. If somebody in future has the same Problem. Have a look at your Z-Speed I slowed it down a lot maybe thats been a Issue. Also I changed my cable routing.
I had the suspission that the heating of my hotend might have an effect on the signal of the probe.
ty for your help