Topics created by Siva

@Siva thanks for the report about the documentation we will check that out.

@Siva the feed rate for homing moves would normally be specified in the homing move command line, so other than when developing the homing files getting the wrong feed rate shouldn't be an issue.

We plan to implement feed hold in a future firmware release.

@T3P3Tony Thanks Tony, sorted now.

@dc42 Thanks this is now resolved by David.

@Siva Hello, may I venture to ask you a question about writing compilation, I ran into some troubles.

@Siva Yes, have a look at the following links:

https://docs.duet3d.com/en/User_manual/Reference/Gcode_meta_commands

and

https://github.com/Duet3D/RepRapFirmware/wiki/Object-Model-Documentation

I also suggest you enable the "Object Model" plugin in DWC to interactively browse the object model. You should be at least on v3.4 to use it.

@Jos_mosa said in Motor Stop Command:

I guess we can not send other commands while that homing is in progress?

Correct, I believe it would be in a "Busy" state while the homing was in progress.