!! working
Thanks for the very prompt reply.
Now first a cup of tea and then endstops
regards
/Sten

Yes, it's plugged in there now and it's working, sorry for the loss of your time

Hi!
I have now found out that i had been running on firmware 3 configuring it with a file created with the version 2 configurator.
It is something that should not be possible to happen when at my age and so many years with computers and electronics but it did......
However i have now have improved myself by running the right version of the configurator.
But immediatly something is not right, the temperature of the bed is -273.1 degrees , filament heater is ok with 20.6 degrees. If i swap the termistor connectors there is no change. I had this working previously though.
I have a sparkcube v1.1 XL
It's a corexy with three zaxis motors
Any idea's of what this is?
regards
/Sten
config.g

!! working
Thanks for the very prompt reply.
Now first a cup of tea and then endstops
regards
/Sten

Hi1
Thanks for answering!

In Settings i have only "User Interface"
About says "Duet Web Control" 2.0.0-RC3 is that right?

Hi!
I've started installation of my duet2 bought some months ago.
i followed instructions and installed the latest firmware and web software. When i'm now about to install endstops and all the other cables i can't see the "machine settings" only UI settings in the webpage.
I had saved a tab in the browser with the old web page and was able to see "machine settings" and also click it.
I really need to see the endstops indications, any help?
I also tried to revert the firmware to the "2" generation but got an
error reporting that duetcombinedIAP file was missing so it is not
possible to revert.