Ok, I made the changes from configtool but I still don't have the sensor displayed?
How do I configure three heaters to display in web control?
I am looking for a basic code to start the configuration with the Duet3 6HC.
Someone could help me?
I finded the information I was looking for after connecting to my router.
When the Duet3 uses a MAC address?
@Danal, Hi Dana, thank you for the information I will watch this!
@T3P3Tony, so I can use the same configuration as for a Duet2!?
No connecting via raspberry!
I must absolutely use raspberry?
I would like to configure my Duet 3 6H to my internet network and I do not find the procedure to well configure?
I would like to know if the sensor filament in pause mode works only if I use an SD card or it can work as well if I use a g-code file through the web interface?