Posts made by tech

Ok, I made the changes from configtool but I still don't have the sensor displayed?

How do I configure three heaters to display in web control?

Thanks

Chris

Hi,

I am looking for a basic code to start the configuration with the Duet3 6HC.
Someone could help me?
Thank you

I finded the information I was looking for after connecting to my router.
Thank you

Christian

Hi,

When the Duet3 uses a MAC address?

Thanks

Chris

@Danal, Hi Dana, thank you for the information I will watch this!

@T3P3Tony, so I can use the same configuration as for a Duet2!?

Thanks

Chris

No connecting via raspberry!

I must absolutely use raspberry?

Thanks

Hi,

I would like to configure my Duet 3 6H to my internet network and I do not find the procedure to well configure?

Thanks

Chris

Hi,
I would like to know if the sensor filament in pause mode works only if I use an SD card or it can work as well if I use a g-code file through the web interface?

Thanks

Chris

Hello
Here's my question, I'm using Daze's sensor sentinel and for the sensor filament function or exactly do I have to put the code M581?

Thanks,

Best Regards

Chris

Hi,

here is my problem, I tried to update the 1.21.1 @ 1.22 frimware and here is the error that appears after pressing Erase and Reset ...Unknown USB Device (Device Descriptor Request Failed).

Is there a way to solve this problem?

Thanks

Chris

Hi,

I follow up on the discussion we had about the chamber temperature. I was wondering if you started the working and when do you expect to see the new version?

Thanks

Best

Chris

Ok, thanks for the follow up!

Best Regards

Chris

Hi,

Do you know when this will be added?

Thanks

Chris

Ok!

Thanks dc42 and RCarlyle

Chris

Hi, Is it possible to change to have the display of the chamber temperature?

Thanks

Chris

@rcarlyle said in Bipolar 8 wires paralle or Series Duet WIFI?:

For a 3d printer, parallel will let the motor run much faster. But you will need twice as much drive current. Do you have motor specs or datasheet?

Here is the information of the step motor!

@rcarlyle said in Bipolar 8 wires paralle or Series Duet WIFI?:

o be clear, you’re taking about an 8-wire bipolar stepper motor, right?

Yes! I use a stepper motor that is 8 wire, so I want to know if I should connect them in series or parallel

Hi, for the connection in bipolar mode 8 wires the connection must you be in paralle with a Duet WIFI?

Thanks

Chris