Posts made by Tim van der Blom

hello,

i am trying to get the mesh grid compensation running only i don't relay know what is happening.

as shown in the picture my calibration is in a unusual shape and is 5 mm below the bed or something. right now it looks like a bowl or something like it.

right now i am using a Duet 2 WiFi with Firmware Version: 2.01(RTOS) (2018-07-26b2) on a delta printer.

i also uploaded some file's so maybe this helps
3_1548884966351_retractprobe.g
2_1548884966351_deployprobe.g
1_1548884966351_config.g
0_1548884966351_bed.g

@phaedrux i updated the information and hope that this is enough for you to help. i also followed the instructions from the link you send me and i have done all the tings that there were in ther

I really need help with my BL Touch

I recently bought a duet of Wi-Fi. after some time I connected all the wires as indicated in the manual and made all the convigurations as described in the manual.

When I first started up my printer everything seemed to work fine until I turned on the auto calibration.

the first four point seem to be working fine without any problems, after the four points my BL Touch stop working and doesn't react to any command. also the LED on the BL Touch doesn't work anymore

in my opinion i have tried everything and still nothing works

i hope that there is someone that can help me so that i can start printing

a few specifications
filmware: RepRapFirmware for Duet 2 WiFi/Ethernet version 2.01(RTOS)

i connected the wires as shown in the picture below

and here are the config file
2_1548506438900_retractprobe.g
1_1548506438900_deployprobe.g
0_1548506438900_config.g
1_1548593344118_homedelta.g
0_1548593344117_bed.g