Topics created by Toastinator

@Toastinator Hello, I tried to install ESS ProTuner software from that link but i think it's deleted from OneDrive. Could you tell me where can I find this software because I checked everywhere but i

@dc42

Just Tried Out your Request with 3.3Beta1

G91 G1 H2 X10 - Moved X10 Y10
G91 G1 H2 X-10 - Moved X-10 Y-10
G91 G1 H2 Y10 - Moved X10 Y-10
G91 G1 H2 Y-10 - Moved X-10 Y10

All Movements were Diagonal. These Movements Seem Unexpected.

Side Note: Changing the Timing to

M569 P40.0 S1 R0 T10:10:10:10 M569 P41.0 S1 R0 T10:10:10:10

Or T5:5:5:5 Seamed to make the Homing Error Go away. Machine now Homes No Issue.

@jay_s_uk

The Datasheet I was given does not Mention any Required Timing. It just says it accepts from 0-200Khz Pulse Frequency.

JSS57P2N Instruction manual

After Changing Timing to T5:5:5:5 and T10:10:10:10, It Seams to Move Fine, But there is Some Type Of error Accumulating. (Or somthing else, lol)

Yesterday, I was Getting Homing Errors. Today Without Changing Anything, Its Homing Fine, But Not waiting for the Hotend to Heatup before Moving. And Look at this Picture of a No Infill Cube. The Infill Filled in Slightly Wavy at the Bottom.

IMG_1942.jpg

@albertshao that's correct, Duet 2 boards have only one externally-visible UART port.