Topics created by trobison

@dc42 Many thanks.

@trobison said in Printer resetting after print upgrade from version 3.3 to 3.4.:

I thought a simple M0 should work.

Yes you're not the first person to notice a difference in behaviour with M0. There was a change noted in the release notes of 3.4 but I don't know if it's behaving as expected right now.

@örjane Cheers. A single M0 doesn't seem to work since the firmware update. I will make the changes you have suggested.

Thank you for your help. I think I have it working. Yes, the F7 was already defined as a fan and that stopped the fan. The servo did work on the endstop pin, but the fan stopped. What I did in the end was:

M950 S0 C"duex.pwm5" ; assign GPIO port 0 to pwm5 on expansion board, servo mode

and use:
M280 P0 S80 ; set 80deg servo position on GPIO port 0
to move the servo. This is all very new to me, thank you for your help.

@phaedrux Hi,

The order was placed on 6th of July 2021 from E3D Online. Delivery was on the 13th of July.
Regards,