Best posts made by Tytn

Boy oh boy do I feel dumb... My heating issue is resolved! The heat block was screwed flush against the V6 heat sink causing the heat to disperse too quickly. Below is an image of the gap I added and it resolved the issue instantly.

@lb
I have the same motors in a coreXY setup and noticed I was getting unexpected movement, redesigned the carriage 3 times to make it more rigid. I was assuming this was where my movement was coming from. Even with a all aluminum design I was still experiencing these movements. Then I noticed one motor was moving slightly more than the other.

The key for me was to increase the T parameter to T3.5:3.5:6:0

As soon as I did that everything ran smooth as butter, you can barely hear these things running. I am running 128 microstepping on the drives.

This slight movement may be whats throwing off your calculations!

I will double check my exact T config later if you need it, I am going off memory here but I am almost positive these are the amounts I had in. I know I had to increase them before everything ran smooth and accurately