Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
@phaedrux said in Print Speed:
@tytn Well the firmware will only execute the feed rates it's commanded to by the slicer...
Unless of course @Tytn has turned up the speed factor.
Boy oh boy do I feel dumb... My heating issue is resolved! 👍 The heat block was screwed flush against the V6 heat sink causing the heat to disperse too quickly. Below is an image of the gap I added and it resolved the issue instantly.
0_1551153339999_ExtruderIssue.jpg
