Topics created by VladimirRus007

I had exactly the same issue on my Leadshine ES-D508. I was using the Duet Expansion Breakout Board for my drivers. And I also noticed the layer shifting becoming less as I increase the micro step, which makes sense, the more distance a single micro step takes, the more layer shift it would cause if it's not recognized by the driver or if it stepped to the wrong direction.
I was force to use the integrated stepper drivers but would love to get the external ones working some day.

@vladimirrus007 said in Brobe sensor does not respond to touch if g29 a second time?:

I successfully started printing after g29. If you do not turn off the printer, the second time g29 will not work. The printer does not respond to pressing.

Do you mean the sensor no longer responds to being pressed, even when you use M119 to test it? If so, that sounds like a problem with the sensor. But if it does respond correctly, then you should be able to run G29 again.

I found a mistake. It was in the wrong pin step for the second driver Y.
I fixed it and it all worked.
Config as was and remained.

thank