Topics created by williamwestonn

heh sorry for not explaining that well, there will be a 14awg cable for a heater that will go half way up to the carriage, i will probably put that on the other side of the printer instead of how i designed it to go 10mm to the right from the 5/25v cables. There will be cable deviders on the printer so ill do it as safe as i can 🙂

[SOLVED]

Vertical lines were made from the motors not being the recommended voltage of what the TMC2660 drives. The minimum maxmotorcurrent is 1.2A. This you can see on the back of your motor. ex;(1004AC = 1.004A)
Replaced my 1.8deg 1A motors with 1.7A 0.9deg motors and there is ny lines anymore.

For what iv found my "Zwobble is some kind of extrusion issue..
Replaced some Ballbearings in my Titan extruder and changed the Acceleration from 10000 to 500. Upped my extrusion speed and its now much better. Im still experiencing some kind of over or underextrusion after a layerchange. But ill test using "force retraction between layers, and see what that does.
Any suggestions?