Topics created by Xenotype

You can connect the 10-pin ribbon cable socket on the PanelDue 7i to the CONN_SD port on the Duet using a 10-way straight through ribbon cable, instead of using the 4-way cable and the PanelDue connector.

Be aware that some USB ports (especially on laptop computers) may not be able to supply enough current for a Duet + 7" PanelDue.

@xenotype said in Creality CR10S - Dual Z homing, one stepper gets out of sync.:

I am at the point of just soldering Z wires together and use one driver instead but i will wait on further instructions first.

If you ever do decide to do it that way, there are already two plugs on the motherboard. The second one is populated with jumpers. Remove them, plug in another motor, and you have two motors in series on the one Z driver.

And... great that you got your desired config going!