Hi,
Where in Europe do I find highend GT2 belts online?
What do I need to look for in a belt?
Please move this post if its in the wrong category.
Hi,
Where in Europe do I find highend GT2 belts online?
What do I need to look for in a belt?
Please move this post if its in the wrong category.
@arnold_r_clark
Thanks Arnold, really appreciate the help.
What kind of config did you guys use for the filafarm pad termistor?
@arnold_r_clark
You’re right, it was cut short inside the sleeve. Thank every one for the pointers.
@arnold_r_clark
Thanks for the info. Just need to figure out the one wire termistor to get going.
Hi
Im about to rebuild my bed with a filabase bed from filafarm.
Its a 230v silicon pad and it comes with a SSR.
My old was a 24v bed.
Do I run same 24v Duet wifi output to control my SSR?
It seems as the termistor in my pad is a single wire 100k termistor, where on the Duet should I connect it?
Going to ground my frame and put in a ground breaker too.
All good now with both changes, thank you
That worked but I got a new error
G32
Error: Bed calibration : 4 factor calibration requested but only 3 points provided
Hi,
I been reading instructions on how to configure manual bed leveling assistant but I cannot get it to work correctly.
I have a carthesian printer and four corner screws to adjust my table.
Can get it to probe using G32 and it does all my four corners but resports back a error:
G32
Error: Number of calibration factors (3) not equal to number of leadscrews (4)
I been trying to figure out how to set this but no luck.
Here are my Bed.g lines
G28 ; home
G30 P0 X0 Y0 Z-99999 ; probe near an adjusting screw
G30 P1 X350 Y0 Z-99999 ; probe near an adjusting screw
G30 P2 X350 Y223 Z-99999 ; probe near an adjusting screw
G30 P4 X0 Y223 Z-99999 S3 ; probe near an adjusting screw and report adjustments needed
Here is my config.g lines
M671 X-15:350:350:-15 Y-12:-12:250:250 P1.0 ;
Any ideas what I do wrong?
@Veti
Yes I did, its working.
Just because I wrote this post it now turns again.
Whatever fixes the problem is good
Hi,
I Duet wifi and I supply it with 24v
I have a E3D v6 24v setup and corresponding e3D fan for hotend.
All has been running great until the fan stopped, I have tested another fan and cables with no luck.
The I took a multimeter and measured voltage on FAN1, it shows 12v.. I have not changed anything.. It should read 24v, right. FAN0 gives 24v..
Can someone explain if Im being stupid or if something changed.. To make it even odder I tested with another Duet Wifi but with same config card.. same result 12 v on FAN1