Super Volcano with BMG and 0.9 Motor Wierd behaviour
-
rectilinear infill? try grid instead
-
Are you using Maestro board? If not M350 line is not OK, but its not the problem here.
Try to set Max volumetric speed in slicer to 20 (it's under Filament settings-Advanced or under Print settings-Speed) and see if it is any better. -
I am using the wifi board and for some reasson with M350 E8, i found better results than 16 microsteps.
I will check the volumetric config on slicer. Thank you. -
If the infill is rectilinear, it is bridging. 0.8 bridge flow ratio x 0.7 line width = 0.56 mm, not too far from what you're measuring. When bridging the line won't get squashed flat, so it will probably measure narrower than the calculated value, which means it's probably about right.
-
Had never though that rectalinear might be considered bridging. Makes sense and i will test more infill patterns to compare. Thank you
-
Apologize for reviving such an old post but would be really interested to hear where you ended up and if you wouldn't mind sharing your Prusaslicer profile!
-
@singhm29 No problem sharing my current profile for my Ratrig CoreXY. Would you like PLA or PETG? Remember that this is for a SuperVolcano
-
I see no linear or non-linear extrusion correction. Was that checked?
-
@TonyGR PLA please! Yep tackling the supervolcano as well. What nozzle size did you end up sticking with?
-
@TonyGR don't forget about me
