Slow printing whit duet2 wifi on ender 3 pro
-
set the g code flavour to reprap in the printer config in cura.
-
@Veti that's how it is already imaged, but it still prints slowly
-
post the beginning of a g code where it is slow.
-
@Veti what do you mean?
-
@hannes0913 the file you are trying to print, that is printing slow. Please upload that.
-
@Veti
M201 X500.00 Y500.00 Z100.00 E5000.00 ;Setup machine max acceleration
M203 X500.00 Y500.00 Z10.00 E50.00 ;Setup machine max feedrate
M204 P500.00 R1000.00 T500.00 ;Setup Print/Retract/Travel acceleration
M205 X8.00 Y8.00 Z0.40 E5.00 ;Setup Jerk
M220 S100 ;Reset Feedrate
M221 S100 ;Reset FlowrateG28 ;Home
G92 E0 ;Reset Extruder
G1 Z2.0 F3000 ;Move Z Axis up
G1 X10.1 Y20 Z0.28 F5000.0 ;Move to start position
G1 X10.1 Y200.0 Z0.28 F1500.0 E15 ;Draw the first line
G1 X10.4 Y200.0 Z0.28 F5000.0 ;Move to side a little
G1 X10.4 Y20 Z0.28 F1500.0 E30 ;Draw the second line
G92 E0 ;Reset Extruder
G1 Z2.0 F3000 ;Move Z Axis up -
Your jerk is really low. I would multiply that by at least 60. Don't for get it's in mm/min
-
@hannes0913 said in Slow printing whit duet2 wifi on ender 3 pro:
M203 X500.00 Y500.00 Z10.00 E50.00 ;Setup machine max feedrate
that is in mm/min
500mm/sec is 8.3 mm/sec. that is really slow
are you sure that you set the flavor to reprap in cura?
-
@Veti If you are running a recent version of Cura it comes with a pre-configured set of profiles for the Ender 3. I had the same problem. I assume that your speed settings shown above are in the Cura start.g. Go to start.g and comment out M201,M203,M204,M205,M220 and M221. The next print you slice will print at the speeds set up in RRF.
-
ah those are the CreawsomeMod settings. yes. they need to be removed for the duet.
-
Yes that's correct otherwise the printer is extremely slow.
