Brand new Paneldue 7 not connecting (RRF3)
-
Hi, I've just received my first Duet 2 Ethernet with Panel 7" yesterday, I'm a little be confused about a lot of missing feature like notifications and a real user friendly Web GUI, but the worse things is this panel with old school graphics which apparently not working (I can see with an oscilloscope that it send 3.3v data and when a want to test RX the signal is very weird with a lot of parasites).
So no effects on any action on the panel, and no data from the duet (all temperatures stays at 0)
Maybe an issue with RRF3 ? (I hope otherwise it seems that panel and/or this duet board will not have a great future...) -
@toufou54 said in Brand new Paneldue 7 not connecting (RRF3):
(all temperatures stays at 0)
the indicator to look for is top right corner where it says connecting / idle / etc.
in any case, as of 3.1.0 you need to enable the PanelDue port, do you have
M575 P1 S1 B57600in your config.g? ref https://github.com/Duet3D/RepRapFirmware/blob/v3-dev/WHATS_NEW_RRF3.md#reprapfirmware-310 -
Thanks, that what I was thinking, but never found that in Panelduet documentations, maybe it will be good to make a fresh install documentation, because I did read the page you send me, bu only when I plug and update the board before anything else...so I didn't see the panel M575 g-code.
I will get a try right now ! -
That's ok now it's working thanks again
-
@toufou54 said in Brand new Paneldue 7 not connecting (RRF3):
but never found that in Panelduet documentations
Added a note in the PanelDue install for Duet3.
-
@Phaedrux said in Brand new Paneldue 7 not connecting (RRF3):
@toufou54 said in Brand new Paneldue 7 not connecting (RRF3):
but never found that in Panelduet documentations
Added a note in the PanelDue install for Duet3.
M575 P1 S1 B57600 is now applicable to Duet 2 as well
-
@sebkritikel Ah yes, thanks for pointing that out. It's a RRF3 change not specifically a Duet 3 change.
