BL-Touch - multiple problems -

[dutti]

@JoergS5
ITS WORKING!!!!!!
I connected the BL to IO4.
I think the IO7 connector isn´t working.
Refund Duet???
I´m not sure about the ´´^ ´´. Let it like this and its working now.

[JoergS5]

@barbarossa-cologne I am glad to hear that!!

[dutti]

@JoergS5
And NO. I´m a Idiot. the ´´^ `` must be deleted. Thanks Jörg and @Phaedrux

[dc42]

@barbarossa-cologne said in BL-Touch - multiple problems -:

@Phaedrux said in BL-Touch - multiple problems -:

M98 Pconfig.g

´´´Response to long, see console´´.

So switch to the Console page of DWC to see the messages.

I havent connected the expansion board, yet. Is this a problem?

You will get some error messages from running config.g if it refers to ports on an expansion board that isn't connected.

[Phaedrux]

@barbarossa-cologne said in BL-Touch - multiple problems -:

@JoergS5
And NO. I´m a Idiot. the ´´^ `` must be deleted. Thanks Jörg and @Phaedrux

So you're able to use io7 when removing the ^?

[dutti]

@dc42
ok. problem solved.
thanks

[dutti]

@Phaedrux
no IO7 is dead. with or without. no retract or deploy

[JoergS5]

@barbarossa-cologne said in BL-Touch - multiple problems -:

@Phaedrux
no IO7 is dead. with or without. no retract or deploy

I would make an image from the soldered side of io7 and publish so it can be valued whether it may be a soldering problem.

[dutti]

@JoergS5
ok. I´ll do it!

[Phaedrux]

In addition to the photos can you also provide the following:

The output of M122
The output of M98 P"config.g"
Your current config.g

Also please do this test and report the results:

Send M950 J5 C"io7.in", then read the state of the pin by sending: echo sensors.gpIn[5]

Do this both with and without a jumper shorting io7.in to ground.

Result should be 0 with the jumper, 1 without