BL Touch

Gost101

This post is deleted!

peter247

@peter247

Self test is when you first switch on the machine / give it power , the pin will deploy than retract and go solid red.

Gost101

@peter247 It hasn't done that yet so far even after multiple reboots.

peter247

@Gost101

if it doesn't do that it is a bltouch fault and not a configuration fault.
pull the pin and see if it is bent

Gost101

I legit unplugged the bl touch wires and plugged them back in. It did the move thing and actually homed z. lol

peter247

@Gost101

if you get the red flash the deploy and retract doesn't work until you reset it.
reset it by power recycle OR S160 , eg M280 P3 S160

Gost101

Granted it didnt stop and kept going but progress

Gost101

The Z axis wont stop moving down even after the plunger is pushed in.

peter247

@Gost101

can you deploy and retract the probe ?

Gost101

@peter247 I can deploy and retract the probe

Veti

the wires that come with the bltouch are notoriously bad.

Gost101

@Veti Also not long enough to reach my board. lol

peter247

@Gost101

Look like you are using G30 to lower the head on homing .
Can't see a fault on your config.g , but i'm on version 3.1.1 which is different.

Gost101

@peter247 Now the printer wont home Z. lol here is the code for home all. I cannot pin up and down:

; homeall.g
; called to home all axes
;
; generated by RepRapFirmware Configuration Tool v3.1.4 on Sun Sep 27 2020 23:42:27 GMT-0600 (Mountain Daylight Time)
; Y-Axis
G91                ; relative positioning
G1 S1 Y-505 F1800  ; move quickly to Y axis endstop and stop there (first pass)
G1 Y5 F500         ; go back a few mm
G1 S1 Y-505 F360   ; move slowly to Y axis endstop once more (second pass)
G90                ; absolute positioning
; X-Axis
G91                ; relative positioning
G1 S1 X-505 F1800  ; move quickly to X axis endstop and stop there (first pass)
G1 X5 F500         ; go back a few mm
G1 S1 X-505 F360   ; move slowly to X axis endstop once more (second pass)
G90                ; absolute positioning
; Z-Axis
M280 P7 S160
M280 P7 S120
M280 P7 S90 I1         ; Probe Up
M280 P7 S10 I1         ; Probe Down
M280 P7 S90 I1         ; Probe Up
M280 P7 S10 I1         ; Probe Down
M280 P7 S90 I1         ; Probe Up
M280 P7 S10 I1         ; Probe Down
G1 X15 Y15 Z10 F500
G91                    ; relative positioning
G30 		       ; Do a single probe to home our Z axis
G90 		       ; Make sure we are in absolute mode
G1 Z10 F6000           ; Rapidly move the Z axis to Z=10.