Duet 3 Expansion looses Connection

dc42

I can't be sure from the photo, bu it looks to me that you have CAN termination jumpers fitted to both expansion boards. Only the last board in the chain should have them fitted.

vali3d

Hi,
I had all CAN termination jumpers connected.
I removed them on the middle one.
But sadly the problem remains.

dc42

What firmware versions are you running?

Is it always the same board that gets out of sync? If so, when you swapped the expansion boards over, did the fault move with the board, or not?

vali3d

I am running the version: RepRapFirmware for Duet 3 MB6HC v0.6 or 1.0 version 3.0beta12 running on Duet 3 MB6HC
Yes, it is allways the same board and the fault moves with the board.

jay_s_uk

@vali3d I would suggest you look at moving to 3.1.1 for the main board and 3.1.0 for the expansion boards first.

vali3d

Ok, I have updated it now. This was quite some troubble, I had to completly redo the sd card. I will see if that helped in the next few days/weeks.
Thanks

dc42

Thanks. If that doesn't fix it, I will provide beta firmware for you to try. It turned out that the released firmware runs one of the PLLs in the chip out-of-specification, which could explain a difference between two boards even if neither is faulty.

bot

Slightly off topic, but I really like the electronics cabinet you have (and that power supply looks nice too). Do you recall where/what model you purchased for the cabinet?

vali3d

@bot https://www.dold-mechatronik.de/AE-Kompakt-Schaltschrank-Abmessung-waehlbar

vali3d

Hi,
the expansion lost connection multiple times over the past weeks. According to my obsevations, this happens only under a load on the extruder motors (which are connected to the expansion).

Valentin

Phaedrux

Can you send M122 Bx where X is the board number?

vali3d

@Phaedrux When the connection was lost or in normal operation?

vali3d

Hi,

I have checked the M122 B1/2 comand. The firmeware update I installed in September, didn´t install the firmeware to the expansions, only to the mainboard. Now I manualy installed the 3.2beta to expansions (with the M997 B1/2) an the mainboard. I keep you updated.