Duet 3 : No tool nor bed shown

[Donpi]

@Veti My duet web control is 3.1.1

[Donpi]

Hum the macro is not saved in the micro SD ... I think the problem is from here ...

[droftarts]

@Donpi If you're using SBC, you shouldn't have an SD card in the Duet! The O: directory is a virtual SD drive on the Raspberry Pi. See https://duet3d.dozuki.com/Wiki/Getting_Started_With_Duet_3#Section_Virtual_SD_card

Where is your config.g? On the SD card in the Duet, or on the Raspberry Pi?

Ian

[Donpi]

@droftarts
Of cours in the raspberry
There is no card on de Duet

[Donpi]

Hooo... could it be that the partition I see on windows is the one for the Duet in standalone mode.
And that the partition use by the Raspberry Bi is not visible on windows ?

[droftarts]

@Donpi said in Duet 3 : No tool nor bed shown:

Hooo... could it be that the partition I see on windows is the one for the Duet in standalone mode.
And that the partition use by the Raspberry Bi is not visible on windows ?

Very likely!

Ian

[Donpi]

All that for this ...
Sorry for the time lost

[Veti]

@Donpi

you are making the changes on the sd card in windows?

[Donpi]

@Veti Yes

[Veti]

why are you not using the editor on the web interface?

[Donpi]

@Veti Now I use IT