Help with setup - solved

jay_s_uk

it helps if you add power to the effector...

jay_s_uk

there should be cables here

RonP

@jay_s_uk hey Jay, those are for the thermistor.
They were there and still didn't work.

jay_s_uk

no, T1 to T4 are the thermistor.
If thats the case, you are feeding power into the thermistor connections.
I suggest you revisit the wiring diagram

RonP

@jay_s_uk Thanks good catch, switched it. Looks like I need to redo the black 6 pin . Heading to bed. Thank you for taking the time to get me on the right path.

RonP

So everything has been redone.
Print lights are working, fans come on as expected, heater cartridge and thermistor work.
tried to power on using usb still no green light.

jay_s_uk

@RonP can you post your config.g?

RonP

@jay_s_uk will be a couple of hours. Had to take dog to the vet.️

RonP

config.g
Here it is

RonP

@jay_s_uk Here you go
config.g

Veti

M305 P0 T100000 B4138 R4700 ; set thermistor + ADC parameters for heater 0
M305 P1 T100000 B4138 R4700 ; set thermistor + ADC parameters for heater 1

B4138 is the default and wrong for your thermistor. look up the correct value in your thermistor documentation

also add a T0 to the end of your config. (is "Select the First Tool on Start-Up" in the configurator)

you also might want to enable "Read config-override.g file at end of startup process (provides similar functionality to the EEPROM option in Marlin)"
makes the calibration for a delta easier.

jay_s_uk

@RonP I can't see anything there that would stop the smart effector from working (i just compared it against my old RRF2 with smart effector config).
What voltage are you working with? 12v or 24v?

RonP

@jay_s_uk 24v

jay_s_uk

@RonP not sure what else I can add then.
I would use a multimeter just to check everything out once more.

RonP

@jay_s_uk hey Jay, went through it all again and it seems good. So does that mean my effector is bad ?
Thanks for taking the time to help me.

jay_s_uk

@RonP I think for @Phaedrux to be able to answer that, he'll be after clear photos of the top and the bottom of the board, ideally without anything attached.
Can you also comment on when and where you purchased it?

dc42

If the green light on the Smart Effector never comes on at all, even at power up, the most likely reason is that it is not getting 3.3V and ground through the 8-pin connector.

RonP

First i want to say thank you for everything.
It is working now.
Couple of suggestions:
1.) The ordering of the connections on the documentation (Smart Effector) doesn't line up with the actual 8 pin. Jay pointed out my error.
2.) Update the documentation to reflect the correct green led light or say it could be over here (empty header) or here (by the 8 pin)

So what i think happened is that we had it working shortly after the 6 pin re-do. I was so focused on the green led near the empty header that i didn't see the green led by the 8 pin.
I just happened to see it when i went to take it apart again and touched the print head and saw the green led by the 8 pin.

But thanks again for all the focus and attention.