12864ZW-10 (CR-10 original) display with Duet 3 mini 5+
-
Hello guys,
I've searched long and hard to find the model of the screen I have for this printer but I cannot figure out anything else than 12864ZW-10.
Will it fit with a Duet 3 Mini 5+?
It is the original display that was on the customer's CR-10 (original)
-
@Thalios I think the CR-10 had a similar display to the reprap full graphics smart controller, pretty standard display.
Not sure it's compatible.
-
The Duet 3 mini 5+ supportst both ST7920 and and ST7567 based displays. For the Creality display you may need to create your own loom to hook it up.
I have personally tried and failed to use the old display of a CR-20 (different model than on the CR-10) and failed, but that may be because of lack of understanding or the involuntary acetone bath the display took a while ago.
-
i am not sure that 12864 screens work with the mini 5+ at the moment.
i tried a reprap full graphics smart and an ender 3, both work fine on the maestro, just produce a high pitched noise on the mini 5
-
@Veti said in 12864ZW-10 (CR-10 original) display with Duet 3 mini 5+:
just produce a high pitched noise
-
This post is deleted!
