My Mini is not really OK to start with WiFi
-
@tecno Join the very long queue on the config.g going missing .
-
@tecno Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.
-
Hi,
as my reseller only has V0.5 and this would be 3rd board I am not really keen to have another V0.5Any other solution?
Cheers
Bengtps once again today after emergency stop = wifi restart via terminal and config.g was gone
-
@tecno Have we already replaced it under warranty for you? Who is the reseller?
-
Bart in Holland
-
@tecno Ah yes. Thanks for jogging my memory. I am seeing what can be done here.
-
@phaedrux
Is there a workaround for the (potentially) bad SD-card socket?
E.g. add a piece of paper to the SD-card to increase pressure to the contacts?
Or check solder points? -
@phaedrux said in My Mini is not really OK to start with WiFi:
@tecno Ah yes. Thanks for jogging my memory. I am seeing what can be done here.
I just learned that Kent at Filament23D has 1.0 in stock if that makes life easier.
Cheers
Bengt -
@tecno You should have an email.
-
@o_lampe said in My Mini is not really OK to start with WiFi:
@phaedrux
Is there a workaround for the (potentially) bad SD-card socket?
E.g. add a piece of paper to the SD-card to increase pressure to the contacts?
Or check solder points?Well we don't currently know if it's a hardware problem or a firmware problem. Usually with an SD card slot issue the entire card would be unreadable and yet still work fine in a PC. The issue of the config.g disappearing is something new and different. We don't know if it's a problem with the way the config is being saved, or if it's a hardware problem happening during a save. Or something completely different interacting. The first ones that were replaced should be arriving soon for further investigation.
-
@phaedrux said in My Mini is not really OK to start with WiFi:
@tecno You should have an email.
Got one earlier today from Jason assuming that is what you refere to.
-
@tecno Yes, that's me.
