New Duet 2 Ethernet USB problems

frankfisk4

I pulled the SD card and checked it on my PC.

The config.g file does not open and windows asks for the program to open it.

engikeneer

@frankfisk4 open it with notepad, it's just a plain text file

frankfisk4

Hi here is what the text file says.

; Default config.g template for Duet 2
; Replace this with a proper configuration file (e.g from https://configtool.reprapfirmware.org)
;enable UART for testing
M575 P1 B57600 S1
; test network enable
M552 P192.168.1.14
M552 S1
; Display initial welcome message
M291 P"Please go to <a href=""https://www.duet3d.com/StartHere"" target=""_blank"">this</a> page for further instructions on how to set it up." R"Welcome to your new Duet 2!" S1 T0@engikeneer

dc42

@frankfisk4 are you able to communicate with your other board using YAT and the same USB cable? If so, then please fit the Erase jumper to the non-responsive board, press the Reset button, and see if the Bossa port appears on the PC in Device Manager ->Ports. If it doesn't then I will approve a warranty replacement.

Phaedrux

@frankfisk4 said in New Duet 2 Ethernet USB problems:

M552 P192.168.1.14

Can you also change that address to a valid unoccupied address on your network and then try to reach it from a browser or ping while an ethernet cable is connected to the Duet?

On the SD card there should also be a folder called /www/ that has some web files in it.

frankfisk4

Hi, that printer was sold long ago but I'm using it's original USB cable and the one that came with the new duet.
I am still unable to communicate with the board using YAT and any combination of the 3 USB cords or 4 USB PC ports I have access to.
Should I erase the board as you outlined?

Phaedrux

@frankfisk4 said in New Duet 2 Ethernet USB problems:

Should I erase the board as you outlined?

Go for it. Hopefully it will wake up this time.

frankfisk4

Hi,
I did as instructed. Now the2nd LED is on next to to USB port and no Bossa port appears in the device manager.

Where do I go from here?

Thanks
Frank duet 2.jpg

Phaedrux

@frankfisk4 said in New Duet 2 Ethernet USB problems:

Where do I go from here?

Can you communicate with it via YAT now?

frankfisk4

No and it doesn't show in the device menu either.

Phaedrux

Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.

frankfisk4

Thank you for the help.
The new DUET WIFI showed up today and installed as per instructions.
Thanks
Frank