Thanks! Bad wire. Fixed.

X axis will not home.
I have a D2 WIFI.
When I try to home X it moves 3mm in + direction and stops.
I swapped X and Y wiring and the problem persists.
The firmware is updated.
The X will move a limited amount (30mm?) when using the web control.
Any Ideas?

Thank you for the help.
The new DUET WIFI showed up today and installed as per instructions.
Thanks
Frank

No and it doesn't show in the device menu either.

Hi,
I did as instructed. Now the2nd LED is on next to to USB port and no Bossa port appears in the device manager.

Where do I go from here?

Thanks
Frank

Hi, that printer was sold long ago but I'm using it's original USB cable and the one that came with the new duet.
I am still unable to communicate with the board using YAT and any combination of the 3 USB cords or 4 USB PC ports I have access to.
Should I erase the board as you outlined?

Hi here is what the text file says.

; Default config.g template for Duet 2
; Replace this with a proper configuration file (e.g from https://configtool.reprapfirmware.org)
;enable UART for testing
M575 P1 B57600 S1
; test network enable
M552 P192.168.1.14
M552 S1
; Display initial welcome message
M291 P"Please go to <a href=""https://www.duet3d.com/StartHere"" target=""_blank"">this</a> page for further instructions on how to set it up." R"Welcome to your new Duet 2!" S1 T0@engikeneer

I pulled the SD card and checked it on my PC.

The config.g file does not open and windows asks for the program to open it.

Yes Sir,

I've had another ethernet duet connected to this PC and it worked fine.

I tried YAT with no success.
I am trying to go through Getting connected. This is where the problem is.
I am trying to load the firmware and I have no USB connectivity.
I've tried several ports and 3 different cables.
Is this the info you require?

I've gone through all the steps to connect and reset the card.
It is still unresponsive.
With USB power applied all the lights light up and stay on, 5.0, 3.3 volt and DIAG.
The next step is to erase the firmware.
Should I proceed?