Accelerometers on a bedslinger

tecno

Cables fixed today, one accelerometer and the other to have IO1 extended outside for easier tests not needed to breakdown the printer from is cabinet.

tecno

2021-08-09 13:35:50 M955 P0
Error: M955: Accelerometer not found

2021-08-09 13:29:40 M955 P0 C"io3.out+io3.in"
Error: M955: Accelerometer not found on specified port

Any suggestions what to do next?

dc42

@tecno are those results with or without the extension cable? The ribbon cable by itself should be OK if it is made up the same as the one I illustrated at https://duet3d.dozuki.com/Wiki/Accelerometers#Section_Direct_SPI_connection_to_a_Duet_main_board.

tecno

@dc42
1m and to your spec. Have continuity tested the cable/connectors. NO extension.

tecno

These are going back to seller, I do not believe these are DSH. Board looks very different to others on market. Ordered new from PureTek in UK that are on its way.

dc42

@tecno confirm you are using RRF 3.4beta2 ? Earlier versions do not support the LIS3DSH.

tecno

@dc42
Still on 3.3, expected a sign of life.

dc42

@tecno said in Accelerometers on a bedslinger:

@dc42
Still on 3.3, expected a sign of life.

If it's a LIS3DSH (not 3DH) then you won't get any response using 3.3.

o_lampe

@dc42
Is there any benefit in using the DSH variant?

dc42

@o_lampe it has higher resolution, different sampling rates and produces a slightly cleaner signal.