How to connect a PanelDue
-
Hello,
my PanelDue is running perfect on my Duet3 MB6HC ... I connect to IO_0
But i have see a picture on a cheap Chinese Shop Site (
) the PanelDue is connected to OUT 6 ???
Will this work too?
-
@crazycreator it will not
-
@jay_s_uk
I thought so.
Because in the documentary it's also quite different.Stupid guys
-
-
You're absolutely right
-
@jay_s_uk said in How to connect a PanelDue:
@crazycreator it will not
The photographer decided that this connector will give the best picture composition.
-
@zapta I think they didn't know where to plug it in, because the PanelDue has a 4 pin molex shell on it's wire, when it needs a 5-pin shell to plug in on the MB6HC mainboard. So chose a header where it fitted. The screen content looks like a piece of paper placed on top of the PanelDue; the red bar at the top looks wobbly, like it's curling up! But then the board has got no power, so how can it be showing anything, anyway?
Ian
TronXY X5S with Duet 3 MB6HC and Roto toolboard : Cartesian bed-slinger with Duet 3 Mini 5+ WiFi and 1LC : RRP Fisher Delta v1 with Duet 2 Maestro : Polargraph with Duet 2 WiFi
-
@droftarts said in How to connect a PanelDue:
The screen content looks like a piece of paper placed on top of the PanelDue; the red bar at the top looks wobbly, like it's curling up!
Photoshop is hard, let's fake it in camera! A+ for thinking outside the box.
-
@droftarts I was looking for info on the wiring of my 7" screen when one place tells me to connect the ribbon cable with the 10 pin plug. When i've had the 4 wire plugged in and it works as far as the screen responding to the touch. But not seeming to make any changes or movements to the printer. So do I need the both of them plugged in at the same time?
-
@billsherenow It's usually either or. The 10 pin cable allows you to use the SD card slot in the PanelDue for Duets that support it. Otherwise the 4 wire cable is usually the better option.
https://duet3d.dozuki.com/Wiki/PanelDue#Section_Connecting_a_PanelDue
