Voron 2.4 build with duet

james317

@jay_s_uk Thanks will look into duet 3 6hc with tool board

sonderzug

Good day,

IMO the duet 3 6HC is overkill if you're not planning on going super fast or high accelerations (to the like of Vez3D etc on youtube)

I've done the Voron 2.4 with a duet 3 mini + 2x expansion, as well as the 1LC toolboard which simplifies wiring the gantry a lot. I'm moving the print head around at up to 300 m/s comfortably (haven't tested for more).

Anyway, the 1LC toolboard is a recommendation no matter what main board you get

R3shY

Having a Duet3 6 HC on a CoreXY build
minding to add compatible accelerometer to your bom if you want
print faster than 60-80mm/s

if youre going to add an 1LC toolboard to your printhead, it has an accelerometer inbuild
https://docs.duet3d.com/en/Duet3D_hardware/Duet_3_family/Duet_3_Toolboard_1LC

theres also a guide for orientation by Nuramori:
https://www.dropbox.com/s/hu2w5mk57l4zqpg/Accelerometer Orientation.pdf

With input shaping actually tested are 300mm/s with a tolerance of 0.1 are possible

james317

@sonderzugThanks still analysing my options
Will the 1LC toolboard be OK at the higher cabinet temperatures

james317

@r3shyThanks will check out the links

jay_s_uk

@james317 my chamber normally hits 50 degrees and its fine in that

zapta

@james317, I am using the mini5 + 2 Duet 3 and it works well for me. I have the standard drag chains and wiring with Teflon wires and am happy with it.

The CAN BUS toolboard may be a good choice but I didn't go with it because of its relatively large size.

sonderzug

I've designed a mount that integrates the 1LC toolboard to the new Stealthburner print head. I can share it however it is based on the pre-release STL models, and it is possibly flawed in that it doesn't support the tooboard on all four mounting locations and might allow for some vibration which crucially can throw off the accelerometer for tuning input shaping. Aside from that it's tidy and works well.

james317

@sonderzug Hi my plan is to use LGX with the afterburner and toolboard

A Former User

This post is deleted!

james317

@james317 Cool

DMMAGIC

@sonderzug Hi, did you share your file on github or thingiverse?