BLTouch not communicating with my 3 mini
-
@Phaedrux
So I clean the board and above the lights on the board it pretty bad but it clean up very well and I could even tell anything was amiss when I was done. So what do I do from here just buy a new board or is there a way I can pinpoint it more? -
Is there something on the board that all I/O pins other than 5 and 6 have in common that could have fried?
-
If you had an oscilloscope you could check if the servo pin is sending out a signal.
Can you show some close up photos of the board?
-
I don't know what that chip is though.
Does my config look fine? -
Do you have a multimeter you can use to measure the resistance on R28?
-
@Phaedrux Yes I get 9.9 kΏ.
-
all right I did figure out this problem finally. the deploy probe file was messed up, I'm not sure how it slowly got worse and worse but is now working! I do have one more question however, I am geting this error and I do not know what's wrong does anyone here have answer?
thank you for your help!Ender 3 with duet 3 mini, heated chamber, liquid cooling and auto traming Z screws
-
You'd have to share with us the macro
2_tests_completedandconfig_default.gThe error message would make more sense in the context of those macros.
-
@53581 those are old board testing macros. You should not need to run them and can delete them.
Replace with a configuration from the config tool.
-
@T3P3Tony Ok, Thank you!
