Non Duet Hardware with RRF ?
-
@Herve_Smith feel free to swap over to klipper then.
no idea what the eta will be on RP2040 toolboard support -
This post is deleted! -
@Herve_Smith I went with the dirtybird toolhead and let the 1lc hang out there in all its glory lol.
-
@Herve_Smith that's nice looking. I need to revise my toolhead location as I plan on switching to tap and I won't have the rear mounting position available any more.
-
@jay_s_uk tap seems to be pretty good from what I hear. Just not sure if I'll go for it yet.
-
@R4ffers gives me something to do.
at least it'll work nicely with RRF too -
@jay_s_uk aye, let me know how get on especially with your light weight X rail. I've got one on order
-
@R4ffers the lightweight x rail is great. i temporarily had a carbon fibre one but that was awful. worth the investment
-
This post is deleted! -
@Herve_Smith said in Non Duet Hardware with RRF ?:
I just drew up a modified version of the "tap" that is lighter, uses less hardware and uses a pair of cross roller guides instead of a linear rail for stability
Cross roller guides? Do you have a link to those?
-
This post is deleted! -
@Herve_Smith thanks. I've ordered a set in preparation
-
This post is deleted! -
@Herve_Smith awesome thanks for this, just ordered a set
-
@Herve_Smith which sensor have you used and is that a spring?
-
This post is deleted! -
@Herve_Smith that's them ordered too. many thanks
-
@Herve_Smith Are you able to share your files?
-
This post is deleted! -
@Herve_Smith I have this experimental one which mounts the 1LC in the flap, leaves just enough room to allow for the chain and exposes the two buttons which I have programmed to extrude/retract
Voron V2.434 / Duet 3 Mini5+, Duet 3 Expansion Mini 2+, Duet 1LC V1.1 Toolboard
Voron V0.250 / Duet 2 Maestro
